Filter
Top Products
CALLER ID [54]
www.uniden.com
Long Distance calls and Area Code Setting/Cancellation
While the present Caller ID information is displayed, pressing
*
/tone/< will place
or remove the prefix "1" in the display to set the call for a long distance call, or
pressing #/
> will set or cancel an area code (see page 30).
Storing Caller ID messages in the Phonebook
Messages shown in the Caller ID list can be stored in the phonebook. The phone
number and name of the party on the Caller ID list can be stored in memory.
1) When the phone is in standby mode, select the Caller ID message to be stored.
Then press the
STORE soft key on the base or the EDIT soft key on the handset.
From the handset, then select
EDIT?
.
Store/Edit Name
appears. If the Caller ID
message is already stored in memory, you will hear a beep and
This data is
already stored!!
appears. The number will not be stored.
2) To complete the setting, follow the steps 3-8 in "Phonebook (Storing Phone
Numbers, Names, Distinctive Rings, and Speed Dial)" on pages 42-43.
•When a long distance call
has been set, "
1
" appears
in the display.
•If a call comes in via a
telephone system that
does not offer Caller ID
service, no information is
stored.
•If the Caller ID message
was received as a private/
unknown number, or the
message does not have
the number, you cannot
store the message in the
phonebook. If it was
received as private/
unknown name, the
message will be stored as
<No Name>.
•Even if the memory is full,
the message will be stored
in the phonebook.
However, the message will
be erased from the Caller
ID list.
note
CALLER ID