Filter
Top Products
Dialing from Standby Mode
1. Pick up the handset.
2. Dial the number on the keypad, or use one of the memory features.
(See USING MEMORY DIALING, page 33).
3. Press
line 1
.
4. When you finish the call, press
line 1
, or return the handset to
the base.
If you are dialing in the pulse mode
and need to enter tone digits, press
tone
then enter the digits. Once the call has
ended, tone mode is canceled and pulse
dialing resumes.
If you have Call Waiting service and a
call waiting tone sounds, press
flash
to
accept the call. After a short pause you will
hear the new caller. To return to the
original caller, press
flash
again. The flash
function on the base and handset are
independent of each other. You can use
your flash feature from either the handset
or the base.
FLASH AND CALL WAITING
USING THE TONE FEATURE
18
You may enter a pause
in the dialing sequence
during On-Hook dialing.
You may not enter a
pause in the dialing
sequence during Off-
Hook dialing.
The tone feature applies
only when the base is set
to pulse.
The flash feature does
not function when line 1
and line 2 are on a
conference call. (See the
3-WAY CONFERENCING
and 4-WAY CONFERENC-
ING, pages 22 and 23.)