Filter
Top Products
30
Remote access away from home
You can operate your answering system from a remote location
using any touch-tone telephone. Use this function to check for
recorded messages, to play or delete messages, to record a new
outgoing message, and to monitor sounds in the room.
1 Call your telephone number.
2 While the greeting message plays, press # and your PIN
code.
If the answering machine is off, let it ring 10 times until the
greeting message plays.
Then, press
# and your PIN code.
3 The answering system announces the time and day stamp
and the number of messages stored in memory. Then the
message playback automatically begins.
4 You may continue to listen to your message or you may
select a command from the following chart.
Command Function
# then 1 Repeat
# then 2 Playing your messages
# then 3 Skipping a message
# then 4 Deleting a message
# then 5 Stop message playback
# then 6 Answering system on
# then 7 Voice memo record/stop
(up to 4 minute recording time)
# then 8 Greeting message record/stop
# then 9 Answer system off
# then Room monitor
5 After all of your messages have played, or the playback time
exceeds 4 minutes, you will hear intermittent tones indicating
that the system is in the command waiting mode. You may
enter another command at this time from the chart above.
6 When you finish, hang up to exit the system.
The answering system automatically returns to standby.
*
You must enter a
command within 15
seconds of entering the
command waiting mode
or the answering system
automatically hangs up
and returns to standby.
The system will only play
back messages for four
minutes and then it
returns to the command
waiting mode. To continue
playing your message,
press # then 2 again
within 15 seconds
During the remote
operation, displays
on the base.