Filter
Top Products
7
Erasing a Stored Number from Memory
Changing the Digital Security Code
Chain Dialing
One-touch priority dialing
Your phone is equipped with three “One-touch priority dial” keys for instant dialing.
You cannot store phone numbers directly into m1, m2, or m3. They are only used to
dial the phone numbers stored into memory locations 1, 2, and 3. (See “Storing a
Phone Number in Memory”.)
To instantly dial phone numbers stored in memory locations 1, 2, or 3, simply press
m1, m2, or m3. (There is no need to press talk. The phone will automatically dial.)
If you press m1, m2, or m3, and no phone number was stored in memory locations
1, 2, or 3, the phone will beep rapidly but will not dial.
The 10 memory locations on the handset are not limited to phone numbers. You may want to store in
memory a group of numbers (up to 16 digits) that you need to enter once your call connects. This is
referred to as Chain Dialing.
An example of this is a bank account number. Once you have called your bank, when you are prompted
to enter the account number, simply press m and then the location where the special number has
been stored.
Store your special number in memory as you would a phone number. (Refer to “Storing a Phone
Number in Memory”.)
Enter a “pause” in the sequence as necessary. A “pause” counts as one digit and represents a two
second delay in time between digits as they are sent.
1) Remove the handset from the base unit.
2) Press m twice.
3) Press the memory location (0-9). A tone indicates that the stored number is erased from memory.
NOTE: You cannot erase the phone numbers by using m1, m2, or m3. These are the numbers stored
in memory location 1, 2, and 3.
The digital security code is an identification code used to connect the handset and the base unit.
Normally, setting the code is not necessary.
The first time you charge your handset, the security code is automatically set. In the rare situation that
you suspect another cordless telephone is using the same security code, you can change the code.
1) Remove the handset from the base unit. Press and hold page/find on the base.
2) The handset begins emitting a paging sound. While holding page/find for at least 3 seconds, place
the handset on the base unit. The paging sound stops. Leave the handset on the base for more than
5 seconds or until the status LED stops flashing. A new random security code is set.
NOTE: If the handset battery pack is completely discharged or the battery pack is removed, the digital
security code will be lost. If this happens, a new security code is set automatically next time the
battery pack is charged.
EXP2800_ENG 7/6/01 4:11 PM Page 7