Filter
Top Products
4) Place the handset on the base.
NOTE: Use only the Uniden Battery (BT-905) supplied with your phone. Replacement batteries are also
available through the Uniden Parts Department.
Battery use time (per charge)
From fully charged
• Seven hours continuous use
• Fourteen days when the handset is in the standby mode
Low Battery Alert
When the battery pack is very low and needs to be charged, the phone is programmed to eliminate
functions in order to save power. If the phone is not in use, the talk/batt LED flashes when the battery
pack is low.
If the phone is in use, the talk/batt LED flashes and the handset beeps. Complete your conversation as
quickly as possible and return the handset to the base for charging.
NOTE: The last number dialed in the redial memory and the numbers stored in the memory locations
are retained for up to 1 minute while you replace the battery pack.
Cleaning the Battery Charging Contacts
To maintain a good charge, it is important to clean the battery
contacts on the handset and base unit with a dry cloth or a pencil
eraser about once a month.
Do not use any liquids or solvents.
NOTES: • Even when the battery pack is not being used, it will gradually discharge over a long period
of time. For optimum performance, be sure to return the handset to the base unit after each
telephone call.
• If you must replace the battery pack during a telephone call, complete the replacement within
30 seconds, and you can return to the original call.
C.Connect the base unit
1) Connect the AC adapter to the DC IN 9V jack and a
standard 120V AC wall outlet.
2) Set the base unit on a desk or tabletop, and place the
handset on the base unit as shown.
3) Then raise the antenna to a vertical position.
4) Make sure the status LED lights. If the LED does not light,
check to see that the AC adapter is plugged in and the
handset makes good contact with the base charging contacts.
NOTICE: Place the power cord so it does not create a trip hazard or where it
could become chafed and create a fire or electrical hazard.
NOTES: • Use only the supplied AD-310 AC adapter. Do not use any other
AC adapter.
• Connect the AC adapter to a continuous power supply.
• Place the base unit close to the AC outlet so that you can unplug the AC adapter easily.
• The handset can be placed face up or face down in the base for charging.
2
EXP2800_ENG 7/6/01 4:11 PM Page 2