Filter
Top Products
GETTING STARTED [15]
www.uniden.com
Choosing the Dialing Mode
Most phone systems use tone dialing. However some phone systems (such as in rural areas)
still use pulse dialing. Your Uniden phone supports both tone and pulse dialing. The default
setting is tone dialing. If your phone system uses pulse dialing, follow the steps below to
change the dialing mode:
1) When the phone is in standby mode, press and hold the caller id/
menu key. The following screen appears.
2) Press the /vol/ key three times to select
Dial
.
3) Press the select key to set the phone to pulse dialing.
4) Press the end key to complete the setting. The handset returns to
standby mode.
Setting the Language
There are three languages to choose from; English, French and Spanish.
1) When the phone is in standby mode, press and hold the caller id/
menu key. The following screen appears.
2) Press the /vol/ key four times to select
Language
.
3) Press the select key to select
Eng
,
Fr.
or
Esp.
4) Press the end key to complete the setting. The handset returns to
standby mode.
•If you are not sure of
your dialing system,
make a trial call. If the
call connects, leave
the setting as is.
Otherwise, set for
pulse dialing.
•If your phone system
requires pulse dialing
and you need to send
DTMF tones during a
call, you can
temporarily switch
over to tone dialing.
(Refer to “Tone Dialing
Switch-over” on
page 19.)
note
GETTING STARTED
UP033BH_EXI7246C.book 15 ページ ２００４年１月１５日 木曜日 午前１１時４７分