Filter
Top Products
Installation
Selecting a Location
Before choosing a location for your new phone, there are some important
guidelines you should consider:
• The location should be close to both a phone jack and continuous power
outlet.
Note: A continuous power outlet is an AC outlet which does not have a
switch to interrupt its power.
• Keep the Base Unit and Handset away from sources of electrical noise such
as motors or fluorescent lighting.
• Be sure there is sufficient space to fully extend the Base Unit antenna.
• The Base Unit can be placed on a desk or tabletop or mounted on a
standard AT&T or GTE wall plate.
• If you decide to mount your phone on the wall, make sure to change the
handset retainer so that the tab which holds the Handset faces up. (See
page 17 for more information.)
• You should charge your new phone for 15-20 hours before completing the
installation or using the Handset.
Telephone Line Outlets
There are two types of phone outlets:
Modular Jack
Most phone equipment available now uses modular jacks. Phone
cords are fitted with a molded plastic connector which plugs into this
type of jack. If you do not have modular phone jacks, contact your
local telephone company for information about their installation.
Hard-wired Jack
Some equipment is wired directly to a phone jack, and these types of
installations require a modular jack converter. This type of installation
is not difficult; however, you should contact your Uniden telephone
dealer or a telephone supply store for advice about the proper adapter
or converter for your particular situation.
10