Filter
Top Products
Wall Installation
Standard Wall Plate Mounting
These phones are designed to be mounted on a
standard AT&T or GTE wall plate.
1. Plug the AC
Adapter into
the Base Unit.
2. Place the AC
Adapter cord
inside the
molded
channel.
3. Plug one end
of the short
telephone cord
into the
TEL LINE
jack
on the Base
Unit.
4. Place the
telephone cord
inside the
molded
channel on the
bottom of the
Base Unit.
Then plug the
other end of
the telephone
cord into the
modular jack
on the wall.
5. Place the
Base Unit on
the posts of
the wall plate
and push
down until it’s
firmly seated.
6. Plug the AC
Adapter into a
standard
120V AC wall
outlet.
Note: Do not
use an outlet
controlled by
a wall switch.
Direct Wall Mounting
If you do not have a standard wall plate, you can
mount your phone directly on a wall. Before
mounting your phone, consider the following:
• Select a location away from electrical cables,
pipes, or other items behind the mounting
location that could cause a hazard when
inserting screws into the wall.
• Make sure the wall material is capable of
supporting the weight of the Base Unit and
Handset.
• Use #10 screws with anchoring devices
suitable for the wall material where the Base
Unit will be placed.
1. Insert two
mounting
screws 3
15
⁄
16
inches apart.
Allow about
3
⁄
16
of an inch
between the
wall and
screw heads
for mounting
the phone.
8 DX834/DXC834