Filter
Top Products
Dialing a Stored Number
To dial a number previously stored in memory, follow
these steps:
1.
Remove the
Handset from the
Base Unit.
2. Press T.
3. Press M.
4. Press the memory location number (0-9).
Chain Dialing
On certain occasions, after dialing a number, you
may be requested by the party or service you are
calling to enter a special access code, such as when
performing a banking transaction. To do this, simply:
1. Store the access code into one of the memory
numbers.
2. Dial the main number.
3.
At the appropriate time, press
M
followed by
the memory location number where the access
code is saved.
Problem Suggestion
Charge light won’t come on when Handset is placed in Base
Unit.
• Make sure AC Adapter is plugged into the Base Unit and
wall outlet.
• Make sure Handset is properly seated in Base Unit.
• Make sure that the charging contacts on the Handset and
Base Unit are clean.
Audio sounds weak and/or scratchy.
• Make sure that the Base Unit antenna is fully extended
and vertical.
• Move the Handset and/or Base Unit to different locations
and try again.
• Press the C button to select another channel.
Can’t make or receive calls.
• Check both ends of the Base Unit telephone line cord.
• Make sure the AC Adapter is plugged into the Base Unit
and wall outlet.
• Disconnect the AC Adapter for a few minutes, and then
reconnect it.
Handset doesn’t ring or receive a page.
• Nickel-Cadmium battery pack may be weak. Charge the
battery on the Base Unit for 15–20 hours.
• Extend the Base Unit antenna vertically.
• The Handset may be too far away from the Base Unit.
• Place the Base Unit away from noise sources.
• The Digital Security Code may be erased. Set the Digital
Code.
DX834/DXC834 19