Filter
Top Products
49
Using the Answering
System
To operate from a remote location, use any touch-tone telephone, and follow these steps:
Call your telephone number and wait for the system to answer. If the answering system is off, it will answer after 1)
about fteen rings and sounds a series of beeps.
During the greeting or the beeps (if answering system is off), press 2) [#] and enter your security code/PIN within
two seconds.
The answering system announces the current time and the number of messages stored in memory. 3)
You hear “To play incoming messages, press pound-two. For help, press pound-zero” followed by a beep.
Enter a remote command from the chart below. You have fteen seconds to enter the rst command; after the 4)
rst command, you have two seconds to enter each command.
If you want to Press If you want to Press
Play incoming
messages
[#] then [2]
The answering system plays back
messages for four minutes, then
waits for another command. To
continue playing your messages,
press [#] then [2] again.
Stop the current operation to
enter a different command.
[#] then [5]
Repeat this message
[#] then [1] after the rst four
seconds of this message
Turn the answering system off [#] then [9]
Go back to the
previous message
[#] then [1] during the rst four
seconds of a message
Turn the answering system on [#] then [6]
Skip this message [#] then [3] Listen to the help prompts [#] then [0]
Delete this message [#] then [4] Exit the system Hang up.
When you nish, you will hear intermittent beeps indicating that the system is in the command waiting mode. 5)
Enter another command from the chart within fteen seconds.
Hang up to exit the system. The answering system automatically returns to its normal standby setting.6)
DSS8955 OM.indb 49 28/7/08 5:21:04 PM