Filter
Top Products
[18]
Installing the Belt Clip
Testing the Connection
1. Line up the holes on each side of the handset. To
attach the belt clip, insert into the holes on each
side of the handset. Press down until it clicks.
2. To remove the belt clip , pull either side of the belt
clip to release the tabs from the holes.
To test your connection try making a call. If your call connects, the settings are fine. If your call does not connect
check the following:
1. Check the AC adapter cord. Make sure it is securely connected to the DC IN 9V connector and to a standard
AC power outlet.
2. Check to make sure the battery is fully charged. (If you don't see the "battery full" icon, check to make sure
the battery is properly connected).
3. Change "dial mode" (instructions follow).