Filter
Top Products
3
Installing the Belt Clip
Line up the tabs with the holes on each side of
the handset. Press the belt clip down until both
tabs click into place.
To remove the belt clip, pull both sides of the clip
to release the tabs from the holes.
Installing the Optional Headset
Your phone may be used with an optional
headset. To use a headset, insert the headset
plug into the headset jack. Headsets may
be purchased by calling the Uniden Parts
Department. See inside the back cover page for
contact information.
Charging the Accessory Handset
The handset is powered by a rechargeable battery pack that
automatically recharges when the handset is placed in the
charger.
Connect the AC adapter to the DC IN 9V jack and to a 240V
AC outlet that is not controlled by a wall switch.
Caution: Use only the Uniden AAD-600S adapter.
Set the charger on a
desk or tabletop, and
place the handset in the
charger with the keypad
facing forward.
Make sure that the
charge LED illuminates.
If the LED does not
illuminate, check to see
that the AC adapter
is plugged in and
the handset makes
good contact with the
charging contacts on the charger.
Charge the handset battery pack for at least 15-20 hours
before using your new handset for the fi rst time.
1.
2.
3.
4.
To AC outlet
To DC IN 9V
AC adapter (supplied)
Route the cord.
Caution: Use only the Uniden AAD-600S adapter.
To AC outlet
To DC IN 9V
AC adapter (supplied)
Route the cord.
Caution: Use only the Uniden AAD-600S adapter.
DECT6005 OM.indd 3DECT6005 OM.indd 3 20/8/07 1:49:20 PM20/8/07 1:49:20 PM