Filter
Top Products
21
Registering the Handset to Another Base
To register a handset to another base:
Make sure the handset battery is fully charged.
On the base, disconnect the base AC adapter. Then press and hold
[nd hs] while you reconnect the adapter.
Keep pressing
[nd hs] until the charge LED starts to blink.
On the handset, Press
[Menu/Select]. Select the REGISTER BASE menu. HANDSET REGISTERING will
appear in the display.
Wait approximately thirty seconds. “REGISTRATION COMPLETE” will be displayed to indicate the handset has
been registered to the base and a handset ID will be automatically assigned.
If REGISTRATION FAILED appears in the LCD, please try these steps again.
Selecting the Base
When your handset is registered to another base, it will automatically connect to the base. A base ID (that is for the
handset only) will be assigned in the order of registration. You can either select a base you want to use manually, or
set to AUTO. If you set to AUTO, when the handset comes out of range, it searches automatically the available base
in order of base ID.
With the phone in standby, press
[Menu/Select]. Select the HANDSET SETUP menu, and then the SELECT
BASE submenu.
Move the cursor to select the base you want to connect to, or choose AUTO to have the handset automatically
select the base.
Press
[Menu/Select]. SEARCHING will appear in the display.
When the base is found, the handset will return to standby. If the base is not found, “SEARCHING” continues
to appear. You can repeat the procedure listed above to return back to the original connection or to nd the
different base.
Notes: • You cannot change bases during a call.
• To conrm which bases the handset is registered to, open the SELECT BASE submenu and use
[ ] and
[ ] to scroll through the list. Press [ ] to close the list and return to standby.
1)
2)
3)
4)
1)
2)
3)
4)