Filter
Top Products
15
Handset Base
Remove the battery cover and disconnect
the battery.
Let dry for at least 3 days with the battery
disconnected and the cover off for
ventilation.
After the handset dries, reconnect the
battery and replace the cover. Recharge the
battery fully (15-20 hours) before using.
1.
2.
3.
Disconnect the AC
adapter to cut off
the power.
Disconnect the
telephone cord.
Let dry for at least
3 days before
reconnecting.
1.
2.
3.
Use only the supplied AC
adapters. Be sure to use the
proper adapter for the base &
any chargers.
Do not place the power cord
where it creates a trip hazard
or where it could become
chafed and create a re or electrical hazard.
Do not place the unit in direct sunlight or subject it to high temperatures.
Fully charged, the baery should provide about 10 hours of talk me and about
7 days of standby me. For best results, return the handset to the cradle aer
each call to keep it fully charged.
When the baery gets too low, the handset shows a low baery alert. If you
hear a strange beep during a call, check the display: if you see the low baery
alert, nish your conversaon as quickly as possible and return the handset to
the cradle. If the handset is in standby, none of the keys will operate.
With normal use, the baery should last about one year. Replace the baery
when the talk me becomes short even when the baery is charged. To buy a
replacement baery, call the Parts Department listed on the front cover.
This equipment contains a rechargeable Nickel-Cadmium (Ni-Cd) baery.
•
•
•
•
•
•
•
AC
adapter
Part number PS-0035
Input voltage 120V AC, 60 Hz
Output voltage 8V AC @ 300mA
Baery
pack
Part number BT-1007
Capacity 500mAh, 2.4V DC
AC
adapter
Part number PS-0035
Input voltage 120V AC, 60 Hz
Output voltage 8V AC @ 300mA
Baery
pack
Part number BT-1007
Capacity 500mAh, 2.4V DC