Uniden D2998-3 Telephone User Manual


 
24 - English
Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adapter and
phone cord from the wall before touching it.
Iftheliquidisonlyontheexteriorhousingofthebaseorhandset,wipeitoff
anduseasnormal.Ifyoucanhearliquidinsidethehousing:
1. Disconnectallcablesandcordsandremoveallcompartmentcovers.
2. Ifliquidisleakingfromanyventorhole,turnthephonesothatventfaces
down.Ifnot,placethelargestventfacedown.
3. Letdryforatleast3days.Checkforliquidinsidethephonebeforereplacing
compartmentcoversandreconnectingcords.
Resetting Stations
Ifyouhaveproblemswiththebase,unplugthebasetoresetit.Plugitbackin
afteratleastaminute.
Ifyouhavetroublewithacordlesshandsetorifyouwanttoreplaceone,reset
it:
1. Pressandhold
flash/exit
and
pOunD (#)
atthesametimeuntil
System Reset
displays(about5seconds).
2. Ifyoustillhavethebasethehandsetisregisteredto,select
Deregister HS
,then
selectthehandsetyouwanttoreset.Ifyoudon'thavethatbaseanymore,
select
Base Unavailable
.
3. Toconfirm,select
Yes
.Thehandsetdisplays
Handset not registered
.
Registering a Handset
Ifyouseea“notregistered”messageonahandset,youmustregisterittoa
basebeforeusingit.
1. Onthebase,openthemenuandselect
Register Handset
.
2. Onthehandset,pressandhold
pOunD (#)
untilthehandsetdisplaysays
Handset Registering
(about2seconds).
3. Waituntilthehandsetdisplaysays
Registration Complete
(about30seconds),
thenpickupthehandsetandpress
talk/enD
.
#
If you don’t hear a dial tone or the display says
Registration Failed
, charge
the battery completely, then try again.