4 Topcom Allure 200
Topcom Allure 200
Note:When the battery indicator is shown, the batteries must be replaced. When the
batteries are removed, you have 5 minutes to replace them. After that time, the
memory will be lost.
Never change batteries when the telephone line is connected !
3.2 Initialization
3.2.1 Display language
After installing the batteries, the default display language is shown.
• Use the Up or Down button to select the desired display language.
• Press the Handsfree button to go to the next setting ‘Memory capacity’
3.2.2 Memory capacity
The maximum capacity of the Allure 200 is 110 entries including names and numbers.
This number can be dedicated to the Phonebook and/or the Caller ID list. In this setting you
have to select the capacity of the Phonebook.
• Use the Up or Down button to select the phonebook memory ‘MAX DATABANK =
XXX (default 032)’
• Press the Handsfree button to confirm the phonebook memory.
• The Caller ID list memory size will be displayed briefly and the unit will go to standby
mode.
To have access to the memory setting, you have to remove the batteries for more than
10 minutes.
All stored information will be erased after initialisation.
4 Settings
4.1 Setting the language of the display text.
When you did not change the language during initialisation, you can select it as follow:
• Press the Volume Up / Delete / button for 3 seconds.
• Use the Up or Down to select the desired display language
• Press the Volume Up / Delete / button to go to the next setting.
• If no button is pressed within 10 seconds, the unit will return to standby mode.
!!! Only the words on the 3rd line of the display will be indicated in the selected
language. In standby the display will indicate ‘ALL CALLS 000’ for indicating the
number of stored calls in the call list only in English.
4.2 Setting the display contrast.
You can select the desired contrast as follows:
• Press the Volume Up / Delete / button for 3 seconds, the display language is
shown.
• Press the Volume Up / Delete / button again.