Filter
Top Products
COMPLEMENTARY NOTES
(1) Automatic Access to Paging
This function facilitates Paging / Paging response from a
Substation TL-600S. Just picking up the Handset of Sub-
station automatically activates Paging or Paging Response
mode.
(2) Required Programming for Automatic Access to Paging
from Handset Substation.
2-1) First, connect a Master Station HF-600M or TL-600M in place
of a Substation TL-600S.
2-2) Program at that station a necessary function for Single Digit
Dialing such as Paging, Paging Response, Personal Number Call
or
etc.
2-3) Then, replace the Master Station with a Substation TL-600S.
2-4) Program "Automatic Access to Paging from Handset Substation
(Function Code 54)" at the Station No. 200 according to the
programming instructions.
(3) Single Digit Dialing and Automatic Access to Paging
By programming "Single Digit Dialing" at any master station, a
single touch of the dial
Number Call", "Paging" or "Paging Response" mode. But in
using a TL-600S and a HF-600S, "Automatic Access to Paging
from Handset Substation" function cannot be adopted only by
programming "Single Digit Dialing" at the station. It also
requires the programming for Function Code 54 at No. 200
Station.
(4) A call to Master Station from Handset or Hands-free/
Handset Substation
"Master/Sub Relationship (Function Code 61)" can be
programmed into Handset Substation TL-600S or Hands-free/
Handset Substation HF-600S etc., where you can call the
relative Master Station by a single touch of the dial
picking up the Handset.
or by
In activating a mode with Hands-free/Handset Substation
HF-600S by picking up the Handset, "Privacy" switch on the
Station is to be "ON" position.
(5) Call by Dialing
& Picking up the Handset
Call to Master Station
Paging Call, Paging Response
or Personal Number Call
By dialing
By picking up
Handset
By dialing
By picking up
Handset
at
HF-620Sor
HF-600S
Function
Necessary
Programming
Single Digit
Dialing
Single Digit
Registration
at Station
Master/sub
Relationship
Programming at
Station No. 200
(Function Code 61)
Automatic Access to Paging
Paging (or Calling)
from Handset Substation
1. Single Digit
Registration
at Station
2. Programming at
Station No.200
(Function Code 54)
at
TL-600S or
HF-600S
(Privacy SW. ON)
at
HF-620S or
HF-600S
at
TL-600S or
HF-600S
(Privacy SW. ON)
Note.
Possible
Impossible
Possible but usually Not to be used
Possible across the tie-lined exchange.
Impossible across the tie-lined exchange.
— 26 —
activates "Station Call", "Personal