Filter
Top Products
Bat tery In stal la tion
En sure that the On/Off vol ume con trol knob is turned off.
Press down and hold down the bat tery re lease latch, slide the
bat tery pack about 1/8 inch back, to ward the latch, un til it
stops. Then lift bat tery pack out. Re place bat ter ies as fol lows:
Fig ure 7-2
Bat tery In stal la tion
WARN ING: Do not place an al ka line TR bat tery pack in any
bat tery charger. Se vere charger and bat ter pack dam age may
re sults.
7-2
3. Load new bat ter ies fol low ing the po lar ity as
shown in bat tery case
1. Open the bat tery pack by in sert ing fin -
ger nail and lift ing.
2. Pull bat tery strap to re move low or
dead bat ter ies.
4.
Start load ing at the end of the case where
the strap is at tached to the case.
5. Be sure strap goes un der bat ter ies.
6.
Tuck end of strap un der door
when plac ing the bat tery cover
back on the case.