Filter
Top Products
TO CHANGE TELEPHONES AFTER PLACING A CALL ON HOLD
1. Place the call on hold as above.
2. Pick up the call at another telephone on the same line. The telephone will detect the
pickup and remove the hold condition at the original telephone.
TO MUTE THE SPEAKERPHONE
1. Press the “MUTE” key on the base. The red LED above the “MUTE” key will light.
The party on the other end will not hear you while the “MUTE” light is illuminated.
2. Press the “MUTE” key again to turn off the mute feature. The “MUTE” indicator
LED will extinquish.
MESSAGE WAITING INDICATOR
When a voice message waiting signal is received, the message-waiting LEDs on both the
handset and base will blink. Both LEDs will turn off once the message has been retrieved.
CONVERTING FROM DESK TO WALL MOUNT
The CL1900 series cordless telephone can easily be used in wall mount applications.
The conversion to wall mount is easiest when the handset and cords are not connected.
1. Located on the top of the telephone, above the speaker grill, is the wall/desk mount
clip. Remove this clip by firmly pushing upward (towards the hookswitch).
2. Flip the clip over (top to bottom) so that the protruding edge is towards the top of the
phone. This edge will hold the handset.
3. Turn the telephone over so the bottom is up, facing you. Place it on a non-abrasive
surface to prevent scratching of the telephone.
4. Locate and remove the mounting bracket. Firmly push back and pull up to remove
two of the four retaining tabs.
5. Rotate the mounting bracket 180 degrees clockwise, so that the mounting eyelet on
the bracket is facing the same direction as the other mounting eyelet located on the bottom
of the telephone.
6. Insert the top two retaining tabs of the mounting brackets into the mounting bracket
slots (located near the middle of the telephone). Then firmly push down to insert the
retaining tabs on the opposite side of the mounting bracket.
7. Connect a 15 foot RJ-45 cord into the jack on the back of the phone labeled “LINE”.
8. Turn the telephone over, and slide the telephone down onto the mounting posts in
downward direction. Both eyelets should line up with the mounting posts.
REPLACEMENT PARTS
Additional battery packs and replacement handsets for the CL1900 series are available
from Teledex. When ordering, please specify the telephone model and quantity desired.
IMPORTANT SAFETY INSTRUCTIONS
When using your telephone equipment, basic safety precautions should always be followed
to reduce the risk of fire, electric shock and injury, including the following:
1) Read and understand all instructions.
2) Follow all warnings and instructions marked on the product.
3) Unplug the product from the wall outlet before cleaning. Do not use liquid cleaner or
aerosol cleaners. Use a damp cloth for cleaning.
4) Do not use this product near water, for example near a bathtub, wash bowl, kitchen
sink, laundry tub, in a wet basement, or near a swimming pool.
5) Do not place this product on an unstable cart, stand or table. The product may fall,
causing serious damage to the product.
6) Slots and openings in the cabinet are provided for ventilation, to protect the telephone
from overheating. These openings must not be blocked or covered. The openings
should never be blocked by placing the product on the bed, sofa, rug or a similar
surface. This product should never be placed near or over a radiator or heat register.
This product should not be placed in a built-in installation unless proper ventilation is
provided.
7) Never push objects of any kind into this product through cabinet slots, as they may
touch dangerous voltage points or cause a short circuit that could result in fire or
electrical shock. Do not spill liquid of any kind on the product.
8) To reduce the risk of electrical shock, do not disassemble this product. Take it to a
qualified serviceperson when service or repair work is required. Opening or removing
covers can expose you to dangerous voltages or other risks. Incorrect reassembly can
cause electric shock when the appliance is subsequently used.
9) Unplug this product from the wall outlet and refer servicing to qualified service
personnel under the following conditions:
• When the power supply cord or plug is damaged or frayed.
• If liquid has been spilled into the product.
• If the product has been exposed to rain or water.
• If the product does not operate normally by following the operating instructions.
Adjust only those controls that are covered by the operating instructions, as
improper adjustment of other controls may result in damage and may require
extensive work by a qualified technician to restore the product to normal operation.
• If the product has been dropped or the cabinet has been damaged.
• If the product exhibits a distinct change in performance.
10) Avoid using a telephone (other than a cordless type) during an electrical storm. There
may be a risk of electrical shock from lightning.
11) Do not use the telephone to report a gas leak while you are in the vicinity of the leak.
PLEASE SAVE THESE INSTRUCTIONS FOR REFERENCE
4 5