Filter
Top Products
INCLUDED IN YOUR PACKAGE
Cordless handset
NiMH battery
Rubber battery screw cover
Phillips screw
Base unit
AC adapter
10 foot, 4-wire RJ-11 line cord
15 foot, 8-wire RJ-45 cable
Clear plastic overlay
User guide
PREPARING TO USE THE CL1900 SERIES TELEPHONE
1. Prepare to install the battery into the cordless handset by firmly pressing down on the
top of the battery cover and sliding it off.
2. Locate the lightly embossed numbers “1” and “2” on the battery’s plastic connector.
3. Insert the battery connector into the handset’s connector with the embossed numbers
facing up.
NOTE:
The handset may “beep” when the battery is connected. This is not an
indication that the telephone is ready to use. To obtain optimal performance of the
telephone, be sure to charge the battery for 15 to 20 hours.
4. Replace the battery compartment cover and retaining screw.
5. Insert the provided rubber screw cover.
6. Turn the telephone base so the back panel is facing you. Insert either end of the RJ-45
cable into the jack on the back of the telephone labeled “LINE.”
7. Insert the other end of the cable into the jack on the AC adapter labeled “PHONE”.
8. Insert one end of the RJ-11 line cord into the jack on the AC adapter labeled “LINE.”
9. Insert the other end of this line cord into a telephone wall outlet jack.
10. Plug the AC adapter into an available, unswitched electrical wall outlet.
11. Remove the plastic overlay and place the paper faceplate over the keys. Replace the
plastic overlay by hooking the tabs on the
overlay into the recessed slots located on both sides.
HINT
: The overlay is easiest to insert when the left or right side tabs are inserted first,
and the middle of the overlay is slightly bowed to allow for insertion of the other tabs.
12. Place the cordless handset on the base unit’s charging cradle.
CHARGING THE BATTERY
The rechargeable nickel metal hydride (NiMH) battery must be fully charged before using
the phone for the first time. It is recommended that the battery pack be charged for approxi-
mately 15 to 20 hours without interruption before use. To charge the battery, place the
handset, keypad down, in the base unit. Make sure the “CHARGE” LED on the base
lights. If the LED does not light:
1. Verify that the AC adapter is plugged in to a live, UNSWITCHED outlet.
2. Verify that the handset is making good contact with the base unit charging contacts.
CL1900 SERIES TELEPHONE DIAGRAM
CONTACTING TELEDEX
Telephone: (408) 363-3100
Mail: 6311 San Ignacio Avenue
San Jose, CA USA 95119
Internet: www.teledex.com
email: sales@teledex.com
Part Number 600-0480-47
Copyright © 2001 Teledex LLC. All rights reserved.
1
Charge LED
Store Key
Flash Key
Programming Port
Auto Dial Keys
M1 - M5
(model CL1905)
M1 - M10 (model CL1910)
DTMF Keys
Volume Keys
Mute
Message Waiting Lamp
Hold Button Page Redial
Speakerphone
Hold
Button
On/Off
Key
Low
Battery
Indicator
Redial/Flash
Volume
Keys
Channel