Filter
Top Products
8
8. Align the bracket's keyhole slots
with the wall plate studs and slide
the base downward to secure it.
9. Press and lift out the handset
holder. Rotate the holder 180
degrees as shown, and then snap
it back into place so it holds the
handset.
10. Fully extend the base’s antenna
and place it in a vertical position.
Mounting the Base Directly
on a Wall
You need two wood screws (not sup-
plied) for this mounting method.
1. Drill two holes 3
15
/
16
inches (100
mm) apart. Then thread a screw
into each hole, letting the heads
extend about
1
/
4
inch (6.5 mm)
from the wall.
2. Plug one end of the supplied long
modular cord into the phone jack
on the back of the base.
3. On the bottom of the base, route
the modular cord downward and
under the left slot's clips. Then
plug the cord's other end into a
modular phone line jack.
(Illus with
callout: Lift)
43-1039.fm Page 8 Tuesday, August 17, 1999 10:12 AM