Filter
Top Products
7
Mounting the Base on
a Wall Plate
You need a standard wall plate (not
supplied) for this mounting method.
1. Plug one end of the short modular
cord into the phone jack on the
back of the base.
2. Route the short cord downward
through the top left slot on the
base's bottom and under the clips
as shown.
3. Route the other end of the short
cord through the hole in the sup-
plied bracket's center.
4. Align the tabs on the bracket with
the slots on the back of the base
and push up on the bracket until it
snaps in place.
Note:
If you later want to remove
the bracket, press
PUSH
and slide
the bracket down to remove it
from the base's bottom.
5. Insert the supplied AC adapter's
barrel plug into the
12V DC
jack on
the back of the base. Then route
the adapter's cord around the
strain relief and through the right
slot on the base's bottom and
under the clips as shown.
6. Plug the adapter into a standard
AC outlet.
7. Plug the modular cord into the
wall plate's jack.
(illus
w/callout:
AC Adapter)
43-1039.fm Page 7 Tuesday, August 17, 1999 10:12 AM