Filter
Top Products
Programming the Area Code into Memory
(Administrator Programmable Only)
An Area Code can be programmed into the phone memory at the option of the Administrator.
The Area Code is programmed into memory to allow the phone to recognize the local area code.
When this number is programmed, the Area Code WILL NOT be dialed when calling back a
number within the same local calling area.
Programming the Area Code into Memory
1. Press and hold the “STORE” key for 6 seconds to enter programming
2. Press the “STORE” key multiple times until “ENTER AREA CODE” is displayed.
3. Enter the area code number of the local area code using the numeric dial pad.
4. Press the “STORE” key to store the area code into memory.
5. To exit the program mode, press “DISC” or continue to the end of programming by press-
ing the “STORE” key multiple times until the display reads “All Setup OK”.
In some areas, the Area Code is required when placing a Local Call
In some areas, the local service provider will use the same area code for local calls. The follow-
ing options are available.
Try each of the following scenarios and use the one with the best result.
1. Program the Area Code first, then place a local test call.
2. Delete the area code and do not program the Access Code. Place a local test call.
3. Program the Area Code into the Access Code location. Place a local test call.
4. Use the keypad to add additional numbers to the displayed number on the screen. Place a
local test call.
ENTER AREA CODE
12/01
PM
12:00
719 - -
ENTER AREA CODE
Set up local area code to
recognize local incoming
calls.
31
NOTE: Depending on your area and dialing pattern, you may obtain the best result by using both the ac-
cess code and area code fields. If these sequences do not work, use the keypad entry as an option for your
Call Back.
!