SpectraLink ROLM PBX Telephone User Manual


 
SpectraLink Corporation LinkPlus Interface Guide
Siemens ROLM PBX System
3.3 Program Rolm
Each handset must be programmed so the Rolm switch will recognize the handset
and allow access to system facilities and features. The Rolm technician or local
system programmer should perform the necessary programming.
Create Template Table for handsets
Set up a template table with features assigned as shown below.
HOLD
CONNEC
T
TRANSFER
LINE 1
LINE 2
LINE 3
LINE 4
LINE 5
LINE
6
LINE 7
LINE 8
LINE 9 FORWD
SYSSP
CONF
TRANS
CAMP
SVRP
T
PHML
MUTE
STASP
CALL WAITING
OPEN
OPEN
OPEN
1
2
3
4
5
6
7
8
9
1
0
26
27
28
29
3
6
37
38
39
3
0
40
31
32
33
34
35
21
22
23
24
25
Note: On the Rolm 8000 and 9000 systems, the PHML button is MSGWT, and the
TRANS button is FLASH.
The technician can customize the table by assigning features to the unused buttons
in the upper quadrant (above Call Waiting, accessed by
FCN 0, FCN 7, and FCN *). Do
not change the assignments for Message Waiting, Hold, Connect, Mute or Transfer;
however, other features and the "Open" buttons can be re-assigned if desired.
Part Number: 72-0171-13-C.doc Page 12