SpectraLink ROLM PBX Telephone User Manual


 
SpectraLink Corporation LinkPlus Interface Guide
Siemens ROLM PBX System
3. Interface Implementation
This section describes the recommended programming to use the Wireless
Telephone System with Siemens Rolm systems. The procedures assume:
The Rolm 8000, 9000, 9200, 9751, or 9006, or a Siemens Hicom 300E is installed
and operational in an approved configuration. See the
Telephone Switch Interface
Matrix
document for tested configurations.
A trained Rolm technician or system administrator will be on site with the
Installer to program the system.
The Link WTS or NetLink Telephony Gateway is installed and the handsets are
available for programming.
3.1 Set the Switch Interface Type
Link 150 MCU
The Link 150 Master Control Unit requires the switch interface type to be
configured using the front panel buttons. The configuration procedures are detailed
in
Link 150 M3 MCU: Installation and Operation
.
Link 3000 MCU
When configuring the Link 3000 MCU, the PBX interfaces are available as sub-menu
selections when defining the Interface Module type using the Link 3000 MCU
Operator’s Console. Refer to
Link 3000 MCU: Operator’s Console
for details on
configuring the Interface Modules.
NetLink Telephony Gateways
Connect to the NetLink Telephony Gateway using the serial or modem interface.
From the Main Menu, choose Gateway Configuration. Scroll to Telephone Switch
Type and press enter to change this field, from the Submenu of PBX types, select
Siemens Rolm. Refer to
NetLink Telephony Gateway: Installation, Configuration, and
Administration
for details on configuring the Telephone Switch Type.
Part Number: 72-0171-13-C.doc Page 10