Filter
Top Products
SOYO G668 Ethernet IP Phone User Guide
15
dhcp: Select this item to enable DHCP mode. With this system, your LAN
or router automatically assigns all the required network parameters to any
device connected to it when the device log on. So, if your LAN or router is
configured to use DHCP addressing, the IP phone’s LAN parameters will
automatically be configured as soon as it is connected to the LAN or router
and powered up.
pppoe： Select this item to enable PPPoE protocol. Some DSL providers
require PPPoE setup. For more information, please contact your DSL
provider.
modem：This function is not supported.
ppp id: With pppoe or modem selected in iptype drop down list, please enter
the user name here.
ppp pin: With pppoe or modem selected in iptype drop down list, please enter
the password here.
local ip: With static ip selected in iptype drop down list, please enter IP
address of IP phone here.
subnet mask: With static ip selected in iptype drop down list, please enter
subnet mask of IP phone here.
router ip: With static ip selected in iptype drop down list, please enter router
IP address of IP phone here.
dns: With static ip selected in iptype drop down list, please enter IP address
of DNS server here.
dns 2: With static ip selected in iptype drop down list, please enter IP address
of backup DNS server here.
mac: MAC address is the physical address supplied by the Ethernet NIC.
Centrality PA168S phone is shipped from the factory with a unique algorism
MAC address printed on the back of the base.
Protocol Settings
Note: Please check with your VoIP service provider for the protocol
settings. Changing the settings without proper guidance may result the IP
phone not functioning.
nat traversal: NAT traversal method the IP phone uses.