Filter
Top Products
4
SAFETY INSTRUCTIONS FOR BATTERIES
Safety Instructions for Batteries
Handset Battery Pack
CAUTION:
Use only a Southwestern Bell Freedom Phone® approved battery pack in the handset
of your GH3012 Cordless Telephone. To reduce the risk of fire or injury, always do the
following when replacing, discarding or charging batteries. When handling the batteries,
be careful not to short the battery with conducting materials such as rings, bracelets,
and keys. The battery or conducting material may overheat and cause burns.
Use only the following type and size of battery pack:
FOR HANDSET UNIT :
a. GP40AAK3BMX 3.6V 400mAHr, GPI International Ltd or
b. BYD D-2/3AA400x3 3.6V 400mAHr, BYD Co.,Ltd or
a. Do not dispose of the battery pack in a fire. The cell may explode. Check with local
codes for possible special disposal instructions.
b. Do not attempt to open or mutilate the battery pack. The chemicals are dangerous
and may cause damage to the eyes or skin, and may be toxic if swallowed.
c. Follow the charge instructions outlined in this manual.
(See page 13)
The EPA certified RBRC®* Battery Recycling Seal on the nickel-cadmium (Ni-Cd)
battery indicates that Southwestern Bell Freedom Phone® Retail Sales is voluntarily
participating in an industry program to collect and recycle these batteries at the end of
their useful life, when taken out of service in the United States or Canada. The RBRC®
program provides a convenient alternative to placing used Ni-Cd batteries into the
trash or the municipal waste stream, which may be illegal in your areas. Please call 1-
800-8-BATTERY for information on Ni-Cd battery recycling and disposal bans /
restrictions in your area. Southwestern Bell Freedom Phone® Retail Sales’s
involvement in this program is part of our commitment to preserving our environment
and conserving our natural resources.
*RBRC® is a trademark of the Rechargeable Battery Recycling Corporation.
Save These Instructions
CONTAINS NICKEL-CADMIUM
BATTERY. BATTERY MUST BE
RECYCLED OR DISPOSED OF
PROPERLY.
5
NAME OF CONTROLS AND INDICATIONS
Handset Controls, Indicators
Antenna
Earpiece
LCD Display
New Call Indicator
Flashes to indicate there
are calls that have not
been reviewed
Memory Button
Used to store or recall
numbers in memory
Delete Button
Used for deleting Caller
ID entries
Redial Button
Redials the last number or
adds a pause
Flash Button
Used to access call
waiting (if available)
Microphone
Receiver Volume
Switch
To adjust the receiver
volume level
Ringer On/Off Switch
Caller ID Review
Buttons
Memory scroll buttons
Caller ID Calls Button
Used to dial the displayed
number
Talk Button
Used to make or to
terminate calls
Keypad
Number buttons
Channel Button
Used to select another
channel for clearer
reception
Mute Button
Ringer
Headset Jack