Filter
Top Products
Additional Information
62
US
Symptom
You hear five short error
beeps when you press (LINE 1)
or (LINE 2).
You hear no dial tone.
The phone does not connect at
all, even though the number
you dial is correct.
The phone does not redial
correctly.
You hear five short error beeps
when you try to redial.
You cannot perform the redial
operations (redialing, checking
and erasing the phone
number), and “CHANNEL
SEARCHING...” appears on the
display.
The handset does not ring.
The base unit does not ring.
Troubleshooting
If you’ve experienced any of the following difficulties while using your
phone, use this troubleshooting guide to help you remedy the problem.
Should any problem persist, consult your nearest Sony dealer.
Making calls
Remedy
• Make sure you have set up the base unit correctly
(page 10).
• Move the handset closer to the base unit.
• Make sure the telephone line cord is securely
connected to the telephone outlet.
• Make sure the battery is fully charged (page 14).
• Make sure the dialing mode is set correctly (page 13).
• Make sure the last dialed number is really the one you
want to dial.
• The number you last dialed exceeds 32 digits
(including the tone and pause digits if used).
• The number you last dialed is erased.
• Move the handset closer to the base unit and perform
the redial operations again.
• Make sure the ringer is turned on (page 38).
• The battery may be weak. Charge the battery for more
than 12 hours (page 14).
• Make sure you have set up the base unit correctly
(page 10).
• Move the handset closer to the base unit.
• Set the L1 or L2 RINGER LEVEL switch on the base
unit to HIGH or LOW.
• Make sure the telephone line cord is securely
connected to the telephone outlet.
Receiving calls