Filter
Top Products
Additional Information
Additional Information
43
US
Symptom
You hear interference during
conversation.
You hear a beep every second
during a conversation and
“OUT OF RANGE” appears on
the display.
You hear a beep every three
seconds and E and “BATTERY
LOW” appear on the display.
You hear five short error beeps
and cannot store a number on a
one-touch dial, speed dialing
key or in the Phone Directory.
You hear five short error beeps
when you try to make a one-
touch or speed dial call.
One-touch dialing, speed
dialing or Phone Directory
dialing is incorrect.
The handset does not ring
when you use the intercom
from the base phone, and the
base phone does not ring when
you use the intercom from the
handset.
When pressing (INTERCOM),
you hear a busy tone and
cannot make an intercom call.
The caller’s name and/or
phone number does not appear
on the display.
Caller ID
One-touch dialing/Speed
dialing/Phone Directory
continued
Intercom
During conversation
Remedy
• Move the handset closer to the base phone.
• Place the base phone away from noise sources
(page 8).
• This is the out-of-range alarm. Move the handset
closer to the base phone within one minute.
• The battery is weak. Charge the battery for more than
12 hours (page 11).
• Make sure you follow the procedure for storing the
number correctly (pages 19, 21 and 23).
• Make sure the number (including the tone and pause
digits) does not exceed 16 digits.
• You have entered a one-touch dialing button or speed
dialing key for which no phone number has been
stored.
• Store the correct number (pages 19, 21 and 23).
• Set the RING switch on the handset to ON.
• The battery may be week. Charge the battery for more
than 12 hours (page 11).
• Move the handset closer to the base phone.
• Place the base phone away from noise sources
(page 8).
• Either the base phone or handset is being used to
converse with an outside caller.
• Make sure you have subscribed to Caller ID service.
• Caller ID service may not work when the phone is
connected to a Private Branch Exchange (PBX).
• Make sure that the handset is on the base phone or set
the RING switch on the handset to ON. (page 32).
• The call is made through company which does not
offer Caller ID service. “OUT OF AREA” will appear
on the display.
• The call was “blocked.” “PRIVATE” will appear on
the display.
• You have answered the call while “** RINGING **”
was displayed. Be sure to answer after the Caller ID
data is displayed.