Filter
Top Products
Basics
14
US
1 Pick up the handset from the
base phone.
2 Press
(TALK/ CALL WAITING/ FLASH)
and wait until “TALK” appears
on the display and the display
also shows the operation
duration in hours, minutes and
seconds.
You’ll then hear a dial tone.
“HANDSET IN USE” appears
on the display of the base phone
and the LINE lamp on the base
phone lights up.
If you hear five short error
beeps and “OUT OF RANGE”
appears on the display, move
closer to the base phone.
3 Dial the phone number.
During a conversation, you can
adjust the handset volume.
Follow the procedure described
in the following table.
4 When you’re done talking, press
(OFF) or place the handset on
the base phone.
The display and the LINE lamp
on the base phone go off.
(REDIAL/PAUSE)
(*TONE)
(VOL/PGM)
Basics
Making calls
To
Adjust the handset volume
Put a call on hold
Switch to tone dialing
temporarily
Do this
During phone conversations, press (VOL/PGM).
Each press of (VOL/PGM) switches the handset
volume by one of four levels.
Press (HOLD). “HOLD” appears on the display.
Press (HOLD) again to resume the conversation.
Press (*TONE) after you’re connected.
The line will remain in tone dialing until
disconnected.
Additional tasks