Filter
Top Products
Basics 25
US
Basics
Do this
Set the VOL switch to H (high), M (middle) or L
(low).
Press (HOLD). “HOLD” appears on the display.
Press (HOLD) again to resume the conversation.
Press (MUTING) to disable the microphone.
“MUTING” appears on the display. Press
(MUTING) again to cancel.
Press (CALL WAITING/ FLASH).
Press (CALL WAITING/ FLASH) again to return to the
first caller.
Press (*TONE) after you’re connected.
The line will remain in tone dialing until
disconnected.
To
Adjust the handset volume
Put a call on hold
Mute your voice
Switch to another call
(“call waiting” service*)
Switch to tone dialing
temporarily
* You need to subscribe to the service from your telephone company.
Notes
• When you increase the sound volume, in some cases the back ground noise
may be increased as well. You should adjust the volume accordingly.
• If your conversation is muted and “CHANNEL SEARCHING” appears on
the display, move closer to the base phone; otherwise, the call will be
disconnected after one minute.
If the battery becomes weak during a call
The handset will beep every three seconds five times and E and
“BATTERY LOW” appears on the display. Finish your call and charge
the battery pack.
For optimum performance, charge the battery for a full 12 hours.
Note that during the first 10 - 15 minutes of charging, the phone will be
inactive, i.e., unable to make or receive a call.
After this initial 10 - 15 minutes, you may be able to use the phone, but
the battery duration will be very short; thus it is recommended that
you fully charge the battery before the next usage.
Additional tasks
continued