Filter
Top Products
Medalist 17240, 13030, 10231, 8420 and 4310, Rev. B 27
3. Remount your drive in the computer and replace the computer
cover.
4. Insert a bootable system diskette into drive A and turn on the
computer. It should boot from drive A and automatically detect
the new drive as a 2.1-Gbyte drive.
5. Insert your DiscWizard diskette into drive A and type A:\DM.
Then press
ENTER
. This runs the Disk Manager program.
6. Follow the Disk Manager instructions to install the dynamic
drive overlay and to partition and format your new drive to its
full capacity.
7. After Disk Manager is done, reboot your system. You should
see the Disk Manager banner and be able to access the full
capacity of your new drive.
The screen remains blank when you power up the system.
If the steps listed above do not remedy this problem, try the fol-
lowing:
•
Make sure the monitor is plugged in and turned on.
•
Check all cards.
•
Make sure the video card is seated in its slot and secured with
mounting screws.
•
Turn off the computer and remove the drive host adapter. If the
screen turns on after you reboot, the host adapter may be
incompatible or defective. If so, see your dealer.
The system does not recognize the drive.
•
Check all cables.
•
Make sure the power supply is adequate for system needs.