Filter
Top Products
INITIAL SETUP (Continued)
9
10
AC connection
1.
2.
3.
Insert the small plug on the end of the AC adaptor cord into the DC 7.5V AC ADAPTOR jack on
the back of the base station.
Plug the AC adaptor into a standard AC120V wall outlet.
Plug one end of the telephone cord into a telephone wall jack and the other into the TEL LINE jack
on the back of the base station.
NOTE:
Use only AC adaptor provided with the telephone.
Wall Telephone Jack
AC Wall Outlet
AC Adaptor
To Telephone Line
7.5
Installing the handset battery and initial charging
1.
2.
3.
The battery pack is already pre-installed in the handset.
Find the battery contact tab on the back of the handset.
Pull the battery contact tab out slowly from the
battery compartment.
Replacement battery:
Nickel Metal Hydride 2.4V 600mAh battery pack.
Using other types of batteries may cause serious damage or equipment malfunctions.
Only replace with an approved battery pack available through SANYO.
Use enclosed form to order.
IMPORTANT: Charge the handset battery for a full 15 hours before using the telephone for the
first time.
If the handset battery is not installed and the handset is placed on the base station cradle, the
incoming ring will not sound.
CAUTION:
Use only the specified battery.
Do not remove the battery from the handset to charge.
Never throw the battery into a fire, disassemble it, or heat it.
Do not remove or damage the battery casing.
Remove the battery if would not use the phone for over 30 days.
Place the handset on the base station for 15 hours.
The indicator in base will light.
The base station must be connected to AC power.
INITIAL SETUP
Low battery
If the handset battery power is low the BATTERY ICON in the display will be empty and you will
hear a warning beep every 15 seconds. If you are on a call, finish your conversation as soon as
possible as your call will be cut in approximately 5 minutes. Recharge the handset for 15 hours before
continuing to use the telephone.
To mount the base station on a wall
1.
2.
Be certain there are no electrical cables, pipes or other items behind the mounting location that could
cause a hazard when inserting the screws into the wall.
Connect the cord to a wall phone plate (not supplied).
Mount the base station on the wall phone plate securely.
WARNING:
Wall mount
7.5
(For CLT-D6222, CLT-D6223)
NOTE:
Battery and handset may become warm during charging. This is normal.
CHARGE
/IN USE
Pull to remove before use
Retirer avant usage
Pull to remove before use
Retirer avant usage