35
36
REPLACE THE BATTERY (Continued)
To replace the battery
Slide off the battery compartment cover
Remove the battery pack from the compartment
Insert the new battery pack according to the battery contacts location
Slide on the battery compartment cover
Place handset on the base to charge for 15 hours
1.
2.
3.
4.
5.
NOTE:
Charge the handset battery for at least 15 hours continuously prior to first use. The initial
charge is important for best performance.
After battery replacement, reset the date and time.
Battery and handset may become warm during charging. This is normal.
Warning:
To avoid the risk of personal injury or property damage from fire or electrical shock, only use
2.4V 600mAh rechargeable battery pack.
Replacement part number 2SN-AAA60H-S-T.
RECYCLING NICKEL-METAL HYDRIDE BATTERIES
NICKEL-METAL HYDRIDE BATTERIES MUST BE DISPOSED
OF PROPERLY.
Please take your used battery pack to a store that recycles
Ni-MH batteries. Call 1-800-822-8837 or go to www.rbrc.ca
POWER FAILURE
During the period that the power is off, you will not be able to make or receive calls with the telephone.
HEADSET JACK
Headset connection (Headset not included)
For hands free conversation, connect the headset (not included) to the HEADSET jack. The handset
earpiece and microphone are disabled when the headset is connected.
For purchasing, servicing or replacement please contact our service center.
SANYO Canada Inc.
1-300 Applewood Cres.
Concord, Ont. L4K 5C7
(905) 760-9944
1-800-263-2244
www.sanyo.ca
Make sure the telephone is off before replacing the battery.
DEFAULT SETTING
Setting default value
Language
Unit name
Backlight time
Area code
Dial mode
Auto talk
Flash time
Contrast
Time format
HS ringer music
HS ringer volume
Page tone
Key tone
No disturb
Alarm
English
Handset
10 seconds
_
Tone
Off
Long (600mS)
level 4
12-hour
01
level 5
04
Tone
Off
Off
NOTE: If you are too far away from the base or the base is off, the Set Default may not succeed.
You will hear an error tone and the display will show "ERROR". Press to exit.