Filter
Top Products
C. Connect the base unit and charging cradle and
charge the handsets
1 Connect each AC adapter
to the DC IN 9V jack and
to each standard 120V
AC wall outlet.
2 Set the base and
charging cradle on a
desk or tabletop, and
place one handset in the
base unit and the other in the charging cradle.
3 Make sure that the CHARGE/IN USE
and CHARGE LED illuminates.
If the LED does not illuminate, check to see that the AC adapter
is plugged in and the handset makes good contact with the
cradle’s charging contacts.
E7
GETTING
STARTED
• Place the handset in the base or charging cradle with the keypad facing
forward for charging.
• Connect the AC adapter to a continuous power supply.
• Place the base unit and charging cradle close to the AC outlets so that you
can unplug the AC adapters easily.
Notes:
• Use only the supplied Sanyo AC adapter. Do not use any other AC adapter.
• Do not place the power cord so that it creates a trip hazard or where it could
become damaged and create a fire or electrical hazard.
IMPORTANT
Route the cord.
UP016DH(CLT5812) ENG OM 3/7/05 5:21 PM Page 7