Filter
Top Products
E38
ADDITIONAL
INFORMATION
The digital security code is an identification code used to connect
each handset and the base unit. Normally, setting the code is not
necessary. The first time you charge each handset in the base, the
security code is automatically set.
In the rare situation that you suspect another cordless telephone is
using the same security code, you can change the code.
1 Remove the handset from the cradle. Press and hold the PAGE
key on the main base.
2 While holding the PAGE key, place the handset in the main base,
and leave it there for more than 3 seconds.
3 Remove the handset from the main base. Then place the second
handset in the main base and wait for more than 3 seconds.
No need to hold the PAGE key this time.
4 Press the TALK/FLASH key on the handset. Once you make sure
Talk
appears on the display, press the END key. Then, try with
the second handset. If each handset displays
Talk
, a new
random security code is set.
Otherwise, return to step 1 and try again.
Changing the digital security code
Installing the beltclip
To attach the beltclip
Insert the beltclip into the holes on each side of the handset.
Press down until it clicks.
To remove the beltclip
Pull both sides of the beltclip to release the tabs from the holes.
If the handset battery pack is completely discharged or the battery pack is
removed, the digital security code will be lost. If this happens, a new security
code is set automatically the next time the battery pack is charged.
Note:
UP016DH(CLT5812) ENG OM 3/7/05 5:23 PM Page 38