Sanyo CLT-2419 Cordless Telephone User Manual


 
SOUND SIGNALS
A long warbling tone Signals an incoming call
Single Tone A key is pressed
Two Long Beeps Confirmation tone
One short beep and one long beep Page signal
Three short beeps Error tone/Out-of-range warning
4 short beeps every 7 seconds Low battery warning
TROUBLESHOOTING
CALLER ID
No Display
Is battery fully charged? Try replacing the battery.
Make sure that the base is connected to a non-switched AC
outlet. Disconnect the base from the plug and plug it in again.
Did you order Caller ID service from your local telephone
company? The display will not work unless you order Caller ID
service from your phone company.
Caller ID Error Message
The phone displays this message if it detects anything other
than valid Caller ID information during the silent period after
the first ring. This message indicates either the presence of
noises on the line, or that an invalid message has been sent
from the telephone company.
TELEPHONE
No dial tone
Check installation:
- Is the base power cord connected to a working outlet?
- Is the telephone line cord connected to the base unit and the
wall jack?
Disconnect the base from the wall jack and connect another
phone to the same jack. If there is no dial tone in the second
phone, the problem might be your wiring or local service.
Is the handset out of range of the base?
Make sure the battery is properly charged (12 continuous
hours).
31
LCD SCREEN MESSAGES
The following indicators show the status of a message or of the
phone.
EERRRROORR
Caller information has been interrupted during transmission
or the phone is excessively noisy.
EENNTTEERR NNAAMMEE
Prompt telling you to enter name in directory.
DDEELLEETTEE AALLLL??
Prompt asking you if you want to erase all Caller ID entries.
DDEELLEETTEE??
Prompt asking you if you want to erase the current Caller ID
entry or a directory entry that is shown on the screen.
EENNDD OOFF LLIISSTT
Indicates that there is no additional information in Caller ID
list.
NNEEWW
Indicates call or calls have not been reviewed.
UUNNKKNNOOWWNN NNUUMMBBEERR//UUNNKKNNOOWWNN NNAAMMEE//UUNNKKNNOOWWNN CCAALLLLEERR
The incoming call is from an area not serviced by Caller ID,
or the information was not sent.
PPAAGGIINNGG
Someone has pressed the PAGE/INTERCOM key on the
base or the INT key on the handset.
BBLLOOCCKKEEDD NNUUMMBBEERR//BBLLOOCCKKEEDD NNAAMMEE//BBLLOOCCKKEEDD CCAALLLLEERR
The person is calling from a number that has been blocked
from transmission.
NNOO DDAATTAA
No Caller ID information was received.
30
CLT-2419-2423E-NEW 3/14/03 3:32 PM Page 30