Filter
Top Products
RECYCLING NICKEL-METAL HYDRIDE BATTERIES
NICKEL-METAL HYDRIDE BATTERIES MUST BE
DISPOSED OF PROPERLY.
Please take your used battery pack to a store that
recycles Ni-MH batteries.
POWER FAILURE
During the period that the power is off, you will not be able to make or
receive calls with the telephone.
After a power outage, place the handset in the base for about
20 seconds to reset the digital security code.
HEADSET JACK AND BELT CLIP
Headset connection (Headset not included)
For hands free conversation, connect the headset
(not included) to the HEADSET jack. The handset
earpiece and microphone are disabled when the
headset is connected.
•Press TALK to answer or place a call while
using the headset.
Belt clip installation
• Attach the belt clip by inserting the sides of
the belt clip into the slots.
• Snap the ends of the belt clip into place.
29
CHANGING THE BATTERY
Battery replacement and handling
When the operating time becomes short even after a battery is
recharged, please replace the battery.
With normal usage, your battery should last about one year.
For a replacement battery, please contact your place of purchase or fill
out and mail the enclosed Battery Order form.
Caution:
• Use only the specified battery type (3.6 V, 600 mAh).
• Do not remove the battery from the handset to charge it.
• Never throw the battery into a fire, disassemble it, or heat it.
• Do not remove or damage the battery casing.
• Remove battery if storing the phone over 30 days.
Make sure the telephone is off before you replace
the battery.
1. Slide off the battery compartment cover.
2. Disconnect the battery plug from the jack
in the compartment and remove the
battery pack.
3. Insert the new battery pack and connect
the cord into the jack.
4. Put the battery compartment cover back
on.
5. Place handset on the base to charge for
12 hours.
Note: If the handset battery is removed for more than 5 minutes, the
directory memory and Caller ID memory will be erased.
Charge the handset battery for 12 continuous hours prior to first use.
The initial battery charge is important for best performance.
Caution: To reduce the risk of fire or personal injury, use a 3.6 V,
600 mAh battery. Replacement part number: GES-3AHRAAAU.
28
1
CLT-2419-2423E-NEW 3/14/03 3:32 PM Page 28