Filter
Top Products
21
Tip: Do not use TALK/CALL BACK (or SPEAKER on base) to
activate custom calling services such as Call Waiting, or you will hang
up the phone.
CHAN (Channel) key
While talking, you might need to manually change the channel in
order to get rid of static. Press and release the CHAN key on the
handset to switch to the next clear channel.
HOLD key
Press HOLD on the handset or base to put a call on hold. To release a
line on hold, press HOLD again or pick up an extension phone.
Note: If you are using the handset, the incoming call indicator flashes.
If you are using the speakerphone the SPEAKER key flashes.
CANCEL key
Press CANCEL to cancel certain commands you initiated. Press
CANCEL to hang up after finishing a call.
TONE key
This feature enables Pulse service phone users to access touch-tone
services offered by banks, credit card companies, etc.
1. Call the bank’s information line.
2. Press TONE after your call is answered.
3. Follow the voice instructions to complete your transaction.
4. Hang up when finished. The phone returns to Pulse service.
Handset locator
This feature helps to locate a misplaced handset.
Press and release PAGE/INTERCOM on the base. The screen shows
PPAAGGIINNGG
. The handset beeps continuously for about 2 minutes or until
you press any key on the handset.
Note: You can still page the handset with the ringer off.
20
MUTE key
To have a private, off-line conversation, use the MUTE feature. The
caller on the other end of the line cannot hear you, but you can still
hear them.
To mute the microphone:
1. Press MUTE on the handset or the base.
2. Press MUTE again to return to your phone conversation. If you
are using the handset, the incoming call indicator flashes. If you
are using the speakerphone, the MUTE key on the base flashes.
MMUUTTEE
shows in either screen.
Low battery warning
If the battery is low, a warning tone consisting of 4 short beeps will
sound from the handset when in TALK mode.
LLOOWW BBAATTTTEERRYY
shows
on screen.
VOICE MAIL/IN USE indicator
• Flashes when you have a new voice mail
• Lights when the handset is in use.
When your subscribe to a voice mail service offered by your phone
company, the phone alerts you when voice mail has been received.
MMEESSSSAAGGEE WWAAIITTIINNGG
appears on screen for 60 seconds when a voice
mail is received. The VOICE MAIL/IN USE indicator on the base
flashes to indicate there is a voice mail waiting. After the voice mail
has been reviewed
MMSSGG WWAAIITTIINNGG OOFFFF
appears on screen and the
VOICE MAIL/IN USE indicator stops flashing.
• This indicator does not work with your answering machine.
Note: The phone will only work with an FSK type of VMWI system. It
will not work with the Stutter Dial Tone type of VMWI system.
BASICS BASICS
CLT-2419-2423E-NEW 3/14/03 3:32 PM Page 20