Filter
Top Products
SAMSUNG Installation
DCS-816 March 1999
6-5
6.5 CTM - CTI Module (TAPI) (Figure 6-4)
The DCS CTM module is required to support CTI (TAPI) in the system. The CTM has a DLI
connection and a personal computer (PC) interface, which can be connected to any DLI port of
DCS-816. The system requires MDF connection for CTM modules and modular jack connection
for a keyset. A PC may connect to the module via the DB9 connector. See Figure 2-3 and refer
to section 2.5 (MDF Cabling).
Using one pair twisted wires, connect each CTM module (via the modular jack marked ‘ DLI IN’ ) to
the DLI port of your choice via the champ connector on the base board and then connect the
module (via the other modular jack marked ‘ KTS OUT’ ) to a keyset. A PC can be connected to
the module via the DB9 connector.
A special PC software package is required to run CTI (TAPI) and how to set up the software is
described in the other document in detail. Contact your dealer for information.
CONNECTING A CTM (TAPI)
25 PAIR CABLE WITH FEMALE CONNECTOR TO THE BASE CHAMP CONNECTOR
FIGURE 6-4
CHAMP CONNECTION
PIN COLOUR CIRCUITS / FUNCTIONS
39/14 BK-BR/ BR/BK T/R, 1
st
DLI port on base
40/15 BK-S/ S-BK T/R, 2
nd
DLI port on base
41/16 Y-BL/ BL-Y T/R, 3
rd
DLI port on base
42/17 Y-O/ O-Y T/R, 4
th
DLI port on base
43/18 Y-GR/ GR-Y T/R, 5
th
DLI port on base
44/19 Y-BR/ BR-Y T/R, 6
th
DLI port on base
45/20 Y-S/ S-Y T/R, 7
th
DLI port on base
46/21 VL-BL/BL-VL T/R, 8
th
DLI port on base
47/22 VL-O/ O-VL T/R, 9
th
DLI port on base
48/23 VL-GR/ GR-VL T/R, 10
th
DLI port on base
49/24 VL-BR/ BR-VL T/R, 11
th
DLI port on base
50/25 VL-S/ S-VL T/R, 12
th
DLI port on base
² CONNECT A CTM TO ANY DLI PORT
² YOU CANNOT INSTALL THE EQUIPMENT
OUTDOORS
² SPECIAL PC SOFTWARE REQUIRED
¡¡
C T £Í
¡¡ ¡¡ ¡¡ ¡¡ ¡¡ ¡¡
£Ð £Ã
CO M1 CO M2
TX D 2 2 3 (R xD)
RX D 3 3 O R 2 (T xD)
GN D 5 5 7 (G ND)
9 PI N 2 5 P IN
P I N A S S I G N M E N T
DLI
¡¤
IN
RS-232-C(DB-9)
KTS
¡¤
OUT
3 4
Technical Manuals Online! - http://www.tech-man.com