Filter
Top Products
13
SECURING
SCREWS
REMOVE
KNOCKOUTS
ADDING A KEYSET
DAUGHTERBOARD MODULE
• Place the keyset face down on a flat surface.
• Remove the base pedestal by placing your thumbs over the attachment clips
and press outward while simultaneously pressing down on the keyset body
with your fingertips.
• Remove the two knockouts from the bottom of the keyset.
• Plug in the daughter module and secure with the two screws provided.
idcs_keyset.qxp 9/23/2005 11:32 AM Page 19
14
OUTSIDE CALLS
MAKING AN OUTSIDE CALL
• Lift the handset and press an idle outside line button,line group button or dial
a line access code to receive dial tone—OR—press an idle outside line button,
line group button or dial a line access code to receive dial tone through the
speaker—OR—press SPEAKER, receive intercom dial tone and dial a line
access code.
• Dial the telephone number.
• Finish the call by replacing the handset or pressing the ANS/RLS key.
NOTE: You will receive No More Calls tone when you attempt to make a call and
there is no key available for that line.
• If Least Cost Routing is enabled on your phone system, this button may be
labeled LCR or accessed by dialing an access code (usually 9).
• If your system is programmed to require an authorization code before making
a call,dial Q plus a valid code before selecting a C.O.line.
• If your system is programmed to require an account code before making a
call, press the ACC button or dial 47 plus a valid bin number, press the ACC
button again and then select a C.O. line. See Account Codes for more informa-
tion.
For more information on authorization and account codes, see your system
administrator.
NOTE:If the Hot Keypad feature has been turned off,you must first lift the handset
or press the SPEAKER key before dialing.
ANSWERING AN OUTSIDE CALL
• Lift the handset and you are automatically connected to the ringing call.
See Ring Preference under Customizing Your Keyset—OR—press the ANS/RLS
key to automatically answer on the speakerphone.
NOTE: If a call is flashing at your keyset but not ringing, you must press the flash-
ing button to answer.
UNIVERSAL ANSWER
Outside lines may be programmed to ring a general alerting device. To answer
calls ringing this device,dial 67 or press the UA key.This device can operate in any
one of the six different ring plans.
NOTE:If the Hot Keypad feature has been turned off,you must first lift the handset
or press the SPEAKER key before dialing.
idcs_keyset.qxp 9/23/2005 11:32 AM Page 20