Filter
Top Products
Most difficulties associated with the Wireless Phone Jack
System are due to improper installation. If the steps below do
not solve your difficulty, remove both units from the electrical
outlets, remove all cords and reinstall making sure to follow
instructions on the previous page.
Your situation (system location, characteristics of the home/office)
can, in some instances, affect performance and occasional inter-
ference may be experienced. Some static, buzzing or humming at
certain locations within the operating area is possible. However,
if you experience unusual levels of noise, follow the trouble
shooting actions below.
PROBLEM ACTION
No dial tone Check connections, check outlet for power,
try new cords, move base and/or extension.
Static/ Move base and/or extension (halogen lamps,
Interference light dimmers, and computer surge protectors
can cause some static).
Can't set Move base and/or extension. Try security
Security Code coding more than once (see page 9).
Can't dial out Decrease distance between units. If problems
continue call customer service.
Does not ring Decrease distance between units. If problems
continue call customer service.
No Dial Tone/ 1. Unplug both the base and extension unit
Rapid Beeping
from electrical outlets and disconnect all
cords from both units.
2. With the tip of a pencil, press the security
button (the recessed black button directly
below the green light on the side of both
units) and hold it for 5 seconds on the base
unit first while unit is unplugged. Repeat
same procedure with the extension unit
while unit is unplugged.
3. Always reconnect the base unit to the elec-
trical outlet and telephone cord first, then
connect the extension(s).
4. You will not need to reactivate the security
buttons again unless you experience inter-
ference from a neighbor’s telephone.
Trouble Shooting
7
926 Manual V2.0(1J9643) 6/10/99 1:39 PM Page 7