Filter
Top Products
Flash
If you subscribe to Call Waiting service from your telephone service provider and you receive an incoming call on
while a call is currently active on the same line, you will hear an audible tone to indicate another call is waiting.
Also, Caller ID information (if available) for the waiting call will be displayed.
1. To connect to the waiting call, press the Flash button on your phone. This will place the origian call on hold
and connect you to the new incoming call.
2.To switch between the two calls, press the ash button.
Inserting a Pause in the Dialing Sequence
Press and hold the # button for 2 seconds to insert a delay in dialing sequence when a pause is needed to wait for a
dial tone (for example, after you dial 9 for an outside line, or to wait for a computer access tone.) Each pause counts
as one digit in the dialing sequence, and is shown as “P” in the display.
Redial
1. Press the Speaker button (speakerphone mode), or press the headset button (headset mode), or pick up the
corded handset from the base.
2.The unit will automatically select the available line. If both lines are available, Line 1 will be used rst.
-OR-
Press a line button to select a line.
3. Press the redial button. The redial number list is shown.
4. Use the VOL (- or +) button to select the number. Press the DIAL Soft key to dial out the number.
NOTE: If the number you dialed is longer than 32 digits, It will not be saved in the redial list and
can’t be redialed.
Reviewing the Redial Numbers
Your phone records up to three previously dialed phone numbers.
1. When the phone is idle, press the redial button.
2. Use the VOL (- or +) button to view previously dialed numbers.
3. While the preferred number is displayed, press the Speaker, Headset, a Line button, or pick up the corded
handset to dial the phone number.
NOTE: If you do not select a line button, the unit will automatically select the rst available line
and the number will be dialed accordingly.
Storing a Redial Record in Directory
1. Make sure your phone is in idle mode. (not in Talk mode)
2. Press the Redial button, then use the VOL (- or +) button to scroll to the desired redial number.
3. Press the STORE Soft key.
4. The screen displays Enter Name. Input a name by pressing the keypad.
18