Filter
Top Products
11
Installing the Batteries
Installing the Handset Battery
CAUTION: To reduce the risk of fire or personal injury, only use the Thomson Inc.
approved Ni-MH battery model 5-2683.
NOTE: You must connect the handset battery before use.
1. Locate the handset battery and battery door which are packaged together inside
a plastic bag and are separated from the handset.
2. Locate the battery compartment on the back of the handset.
3. Plug the battery pack cord into the jack inside the compartment.
NOTE: It is important to maintain the polarity (black and red wires) to the jack inside the
compartment. To ensure proper battery installation, the connector is keyed and can be
inserted only one way.
4. Insert the battery pack.
5. Close the battery compartment by pushing the door up until it snaps into place.
6. Place the handset in the charging cradle.
Allow the handset to charge for 16 hours prior to first use. If you don’t properly charge the
handset, battery performance is compromised.
Connections & Setup
BLACK WIRE
RED WIRE
BA TTER Y
PRESS DOWN
FIRM LY