Filter
Top Products
7
On a Desk Top
1. Plug one end of the supplied long
modular cord into the
TEL.
LINE
jack
on the back of the base.
2. Plug the cord’s other end into a
modular phone line jack.
3. Plug one end of the supplied coiled
handset cord into the jack at the left
side of the base. Plug the other end
into the handset’s jack.
4. Place the handset on the base.
5. Insert the supplied AC adapter’s
barrel plug into the
AC
9V
jack on
the back of the base.
6. Plug the adapter into a standard AC
outlet.
When you first connect power,
_
_
flashes on the message counter as
the TAD runs a self-test. The TAD
beeps and
00
appears when the
test is complete.
On a Wall Plate or Wall
Note: To mount the base directly on the
wall, you need two screws (not supplied)
with heads that fit into the keyhole slots
on the bottom of the base. Drill two holes
3
15
/
16
inches (100 mm) apart. Then thread a
screw into each hole, letting the heads ex-
tend about
3
/
16
inch (5 mm) from the wall.
1. Snap the supplied mounting bracket
into the slots on the bottom of the
TAD as shown.
Note: Be sure the keyhole slots on
the bracket and the TAD are aligned
in the same direction.
2. Plug one end of the supplied short
modular line cord into the
TEL. LINE
jack on the back of the TAD.
TEL. LINE Jack
AC 9V Jack
TEL. LINE Jack