Filter
Top Products
8
PREPARATION
SETTING THE DAY AND
TIME
Follow these steps to set the current day
and time so the TAD-1027 records the
correct day and time of the call with each
phone message.
Note:
If you do not complete each step
within 8 seconds, the TAD-1027 sounds
a three-tone beep and stops setting the
day and time. Start again at Step 1.
1. Use a straightened paper clip to
hold down
CLOCK
until the TAD-
1027 beeps. The TAD then
announces, “Sunday.”
Note
: If necessary, adjust
VOLUME
.
2. To change the day of the week,
repeatedly press
OGM/REPEAT
to
move backward or
PLAY/SKIP
to
move forward until the TAD
announces the desired day of the
week.
3. Press
ANSWER/STOP/DELETE
. The
TAD-1027 beeps once and
announces the hour and “AM” or
“PM.”
4. To change the hour, repeatedly
press
OGM/REPEAT
to move back-
ward or
PLAY/SKIP
to move forward
to the desired hour.
5. Press
ANSWER/STOP/DELETE
. The
TAD-1027 beeps once and an-
nounces the minutes.
6. To change the minutes, repeatedly
press
OGM/REPEAT
to move back-
ward or
PLAY/SKIP
to move forward
to the desired minute.
Note
: You can hold down
OGM/
REPEAT
or
PLAY/SKIP
to move the
minutes in 10-minute increments.
Illus. showing CLOCK
switch.
Illus. showing OGM/REPEAT
and PLAY/SKIP.
Illus. showing ANSWER/
STOP/DELETE.
43-787.fm Page 8 Monday, August 16, 1999 8:11 AM