Filter
Top Products
15
Notes:
• Make sure you press Talk twice to
stop the handset from beeping. If
you press Talk only once, you get
a dial tone.
• If you receive a call while the page
is sounding, the handset stops
beeping and starts ringing.
MEMORY DIALING
You can store up to 20 numbers in
memory, then dial a stored number by
pressing a two-digit memory location
number.
Each number you store can be up to
16 digits long.
Storing a Number in Memory
Note: An error tone sounds and the
phone exits the storing process if you
wait more than 30 seconds between
each key press.
1. Lift the handset.
2. Press Mem. The Talk/Batt Low
indicator blinks.
3. Enter the number and any Tone/
mode changes or Pause
entries (see “Entering a Pause” on
Page 16).
Notes:
• Each Tone/ or Pause entry
uses one digit of memory.
• If you try to enter more than 16
digits, the phone sounds an
error tone and exits the storing
process. Start over at Step 2.
4. Press Mem again, then enter the
two-digit memory location num-
ber (01–20) where you want to
store the number. The handset
beeps twice to indicate that the
number is stored.
43-1096.fm Page 15 Tuesday, August 17, 1999 3:47 PM