Filter
Top Products
10
CONNECTING AND
CHARGING THE
BATTERY PACK
The ET-926 comes with a recharge-
able nickel-cadmium battery pack in
the handset. Before using your phone,
you must connect the battery pack,
then charge it for about 14 hours.
1. Slide the cover in the direction of
the arrow to remove it.
2. Unfasten the plastic retainer strap
and lift the battery pack out of the
compartment. Plug the battery
pack’s connector into the socket in
the compartment. The connector
fits only one way.
3. Replace the battery pack inside
the compartment and refasten the
retainer strap.
4. Replace the cover.
To charge the battery pack, place the
handset upright on the base if you
placed the ET-926 on a desk top, or
hang the handset on the holder if you
mounted it on a wall. The In Use/
Charge indicator on the base lights.
When the handset beeps and the Talk/
Batt Low indicator on the handset
flashes, recharge the battery pack.
Notes:
• If the In Use/Charge indicator
does not light when you place the
handset on the base, be sure the
battery pack and AC adapter are
correctly and securely connected.
Also, check the charging contacts
on the handset and the base. If
the contacts are dirty or tarnished,
clean them with a pencil eraser.
43-1096.fm Page 10 Tuesday, August 17, 1999 3:47 PM