Filter
Top Products
7
Note:
If you connect the phone to a
two-line phone jack with a two-line
cord, do not connect a cord to the
TEL LINE 2
jack or the phone will not
operate properly. Instead, you can
connect another phone device, such
as a fax machine or modem.
To connect the phone to two one-
line phone jacks, plug one end of
the supplied long two-line modular
cord into
TEL LINE 1/2
and plug
another cord (not supplied) into the
TEL LINE 2
jack.
To connect the phone to a single
one-line phone jack, plug one end of
the supplied long modular cord into
the
TEL LINE 1/2
or
TEL LINE 2
jack.
Note:
If you connect the phone to a
single one-line phone jack, do not
press the unused line button or you
might hear feedback.
2. Plug the supplied AC adapter’s bar-
rel plug into the
DC IN 9V
jack on the
back of the base.
3. Route the adapter’s cord through
the strain relief slot on the bottom of
the bracket.
4. Plug the adapter into a standard AC
outlet.
5. Connect the phone cord(s) to the
modular phone line jack(s).
6. Raise the base’s antenna to a verti-
cal position.
On a Wall or Wall Plate
Note:
To mount the base directly on the
wall, you need two screws (not supplied)
with heads that fit into the keyhole slots
on the bottom of the bracket. Drill two
holes 3
15
/
16
inches apart. Then thread a
screw into each hole, letting the heads
extend about
5
/
16
inch from the wall.
43-686.fm Page 7 Friday, September 10, 1999 3:13 PM