Filter
Top Products
15
TROUBLESHOOTING
We do not expect you to have any problems with your ET-652, but if you do, these
suggestions might help.
If you still have problems, disconnect the ET-652. If other phones on the same line
work properly, the fault is in this phone or its installation. If you cannot find the prob-
lem, take the ET-652 to your local RadioShack store for assistance.
Problem Su
gg
estion
No dial tone. Be sure you pressed the correct
LINE
button.
Check that the phone line and handset cords
are securely connected.
Line 1 works, but Line 2 does
not.
Be sure you pressed the correct
LINE
button.
Check that the line cord is correctly connected
to an R14 jack. R14 jacks normally have four
visible wire contacts.
Low volume or unusual
sounds.
Someone has picked up another phone on the
same line. Hang up the other phone.
The LINE 2 indicator stays on
even when the line is not in
use.
Set
LINE 2 DEFEAT
on the back of the base to
OFF
.
Can receive calls, but cannot
make calls.
Set
MODE
correctly for the type of service you
have (see “Setting the Dialing Mode” on
Page 8).
43-652.fm Page 15 Friday, August 13, 1999 11:00 AM